Provision a new device

tutorial

After you have obtained a Mender disk image, you need to write it to the storage of the device.

Prerequisites

A disk image for the device storage

You need an image file to flash to the entire storage of the device. This section assumes that you already have one. If not, please visit Convert a Mender Debian image.

Image files end with the three letters img, but not necessarily only those three letters. Common suffixes are .img, .uefiimg and .sdimg. Sometimes the image is compressed in which case there may be an additional .gz, .xz or .zip suffix. If the image is compressed, you need to uncompress it first with one of the commands below:

# For gz compressed images.
gunzip <IMAGE-NAME>.img.gz

# For xz compressed images.
unxz <IMAGE-NAME>.img.xz

# For zip compressed images.
unzip <IMAGE-NAME>.img.zip

A physical device to provision that uses SD cards

In this initial provisioning you will flash and overwrite everything on the given device storage.

There are several methods to flash storage, and the simplest case is if your device uses an SD card. Currently, this is the approach we assume you take here, but you can use the image file to flash any block device.

Write the disk image to the SD card

Be careful! If you point to the wrong <DEVICE> when executing the command below, you risk overwriting your workstation's local or connected storage devices.

You can write the image to the SD card using the following command:

sudo dd if=<PATH-TO-IMAGE>.img of=<DEVICE> bs=4M && sync

<DEVICE> depends on where you placed your SD card. Normally this would be something like /dev/mmcblk0 or /dev/sdb. If you are unsure how to find the correct device, the Raspberry Pi Foundation provides some nice references that can help you for Linux, Mac OSX and Windows.

The flashing may take a few minutes, depending on the size of the image.

Tip: Many versions of dd support adding the oflag=sync status=progress arguments to get progress information during the flashing. To try it out, use the command sudo dd if=<PATH-TO-IMAGE>.img of=<DEVICE> bs=4M oflag=sync status=progress instead of the command above. Not all versions of dd support these arguments.

We welcome contributions to improve this documentation. To submit a change, use the Edit link at the top of the page or email us at .